http://www.documentbays.org/89959-bs-en-10028-1-2017.html

1 ScopeThis European Standard specifies general technical delivery conditions for flat products for theconstruction of pressure equipment.The general technical delivery conditions in EN 10021 also apply.NOTE Once this European Standard is published in the EU Official Journal (OJEU) under Directive2014/68/EU, presumption of conformity to the Essential Safety Requirements (ESRs) of Directive 2014/68/EU islimited to technical data of materials in this European Standard (Part 1 and the other relevant part of the series)and does not presume adequacy of the material to a specific item of equipment. Consequently, the assessment ofthe technical data stated in this material standard against the design requirements of this specific item ofequipment to verify that the ESRs of Directive 2014/68/EU are satisfied, needs to be done.2 Normative referencesThe following documents, in whole or in part, are normatively referenced in this document and areindispensable for its application. For dated references, only the edition cited applies. For undatedreferences, the latest edition of the referenced document (including any amendments) applies.EN 764-5:2014, Pressure equipment ― Part 5: Inspection documentation of metallic materials andcompliance with the material specificationEN 10020:2000, Definition and classification of grades of steelEN 10021:2006, General technical delivery conditions for steel productsEN 10028-2:2017, Flat products made of steels for pressure purposes ― Part 2: Non-alloy and alloy steelswith specified elevated temperature propertiesEN 10028-3:2017, Flat products made of steels for pressure purposes ― Part 3: Weldable fine grain steels,normalizedEN 10028-4:2017, Flat p roducts m ade o f s teels f or p ressure purposes ― P art 4 : N ickel a lloy s teels withspecified low temperature propertiesEN 10028-5:2017, Flat products made of steels for pressure purposes ― Part 5: Weldable fine grain steels,thermomechanically rolledEN 10028-6:2017, Flat products made of steels for pressure purposes ― Part 6: Weldable fine grain steels,quenched and temperedEN 10028-7:2016, Flat products made of steels for pressure purposes ― Part 7: Stainless steelsEN 10029:2010, Hot-rolled steel plates 3 mm thick or above ― Tolerances on dimensions and shapeEN 10048:1996, Hot rolled narrow steel strip ― Tolerances on dimensions and shapeEN 10051:2010, Continuously hot-rolled strip and plate/sheet cut from wide strip of non-alloy and alloysteels ― Tolerances on dimensions and shapeEN 10079:2007, Definitions of steel products