ANSI/ASSE (Plumbing) 1072-2007

Because this barrier method does not automatically periodically provide water to replenish the trap seal, it must provide a barrier on the inlet side of the trap seal that will minimize evaporation caused by the ambient air on the building side of the trap. This barrier must also provide adequate drainage capabilities required for the floor drains intended use as determined by its design, size installation location. While developing the requirements tests for these devices, certain adverse conditions were taken into consideration: introduction of fouling substances such as dirt/sand, floor wax or grease into the device. Drainage requirements are provided to accommodate infrequent sizeable water flows caused by water line breaks, fixture overflows or backflow preventer discharges.

This product is included inASSE (Plumbing) STANDARDS SET - Performance Requirements for Barrier Type Floor Drain Trap Seal Protection Devices

People Who Bought This Also Bought:
CSA A440-08- NAFS - North American Fenestration Standard/Specification for Windows, Doors, and Skylights, Includes Update No. 1 (2008), Update No. 3 (2009)ANSI/ASME B16.26-2006- Cast Copper Alloy Fittings for Flared Copper TubesASTM C411-05- Standard Test Method for Hot-Surface Performance of High-Temperature Thermal InsulationUL 217- Single and Multiple Station Smoke DetectorsCFR 49CFR 100-185- Code of Federal Regulations - Title 49 Part 100 - Part 185 (HazMat Transportation)NFPA (Fire) 704- Identification of the Fire Hazards of Materials for Emergency Response, 2007 EditionUL 181A- Closure Systems for Use with Rigid Air Ducts and Air ConnectorsUL 651- Schedule 40 and 80 Rigid PVC ConduitNFPA (Fire) 99- Health Care Facilities, 2005 editionUL 181B- Closure Systems for Use with Flexible Air Ducts and Air Connectors